Intermediate Pivots
1251
Intermediate Offset Pivot
Full Mortise Handed
- Leaf Height of 2 1/2" (63.5mm) with no
vertical load capacity - Maintains alignment of the door
- Investment cast stainless steel
- Needle Bearings
- Available in standard archtectual finishes
- Suggested for use with 1231S or 1238S
1257
Intermediate Offset Pivot
Full Mortise (Handed)Technical Note: On labeled door NFPA 80 requires one intermediate pivot per door height up to 90˝ (2286)mm and two intermediate pivots for doors from 90˝(2286)mm to 120˝ (3048)mm
- Maintainss align of the door
- 3/4" offset (38.1mm)
- Investment cast stainless steel
- Needle Bearings
- Available in standard archtectual finishes
- Suggested for use with 1235S or 1237S
1258
Intermediate Pivot (Handed)
Technical Note: On labeled doors NFPA 80 requires one intermediate pivot per door height up to 90˝ (2286)mm and two intermediate pivots for doors from 90˝(2286)mm to 120˝ (3048)mm
- Maintains align of the door
- 1 1/2" offset (38.1mm)
- Investment cast stainless steel
- Needle Bearings
- Available in standard archtectual finishes
- Intermediate pivot 1258 suggested
